Viper Remote Start Reset After Dead Battery. 2) disconnect battery to reset alarm computer for 5 minutes or so, and reconnect it. Turn your key to the off position — the car lights should turn off.
Step 4press the program switch on the viper. It is a black wire with a white stripe and is located in the viper remote start system. To do this, you will need to locate the valet switch or button associated with the aftermarket alarm system.
Table of Contents
Step 4Press The Program Switch On The Viper.
They could have bumped it while replacing the battery and bent the bracket so the sensor reads open even when the hood is closed. Search for your car’s alarm transmitter. Listen and wait for your alarm to sound.
Users Can Also Use Shortcuts Such As “M” (Menus), “H” (Headings), “F” (Forms), “B” (Buttons), And “G” (Graphics) To Jump To Specific Elements.
Remote start not working after car battery replacement. Within five seconds of turning it on, turn your key back to the off position (or press the start button again). Hi guys, i have a prostart ct3471 tw remote starter that stop working after my car battery die.
Press And Hold The Disarm Button On Your Remote Until The Alarm Turns Off.
Press and hold the program switch on your car's alarm transmitter. Listen and wait for about six seconds before pressing the lock button on your car's remote. Also, how do you reset a viper?
Press And Hold The Lock Button On Your Fob Remote Car Starter For One Second.
I can start and run the vehicle normally with the key. After you find it, press the “program switch” (a switch that is on the transmitter) seven times and then press and hold on the eighth one. If you hear a chirping sound, then you can press the lock button to reprogram your viper remote.
Toggle The Key From On And Off To Exit Out The Valet Mode 2.
Press and hold the lock button on your fob remote car starter for one second. Look for the hood safety switch. Vehicle sat for close to two months not running, battery completely died.